c) Ensure that it is oriented so that the “Nitrogen” label and pressure gauge face the front of
the cabinet.
5. Install air compressor and bracket to back side of cabinet enclosure.
a) The air compressor assembly will be shipped and installed on the air compressor bracket.
b) The bracket needs to be bolted in place into the proper location at the back of the cabinet.
c) It is designed to use Qty. Four (4) 1/4”-20 bolts.
d) For mounting pattern see General Arrangement drawing supplied with system.
6. Install the N
2
-BLAST
®
electrical enclosure into the Reliable cabinet:
a) The electrical enclosure, FPS-00900-Reliable-01, will be shipped fully assembled.
b) The cabinet is designed for Qty. Four (4) 1/4”-20 hardware.
c) For the location and mounting pattern see the General Arrangement drawing.
d) Ensure that the PLC, gauge and switches all face the front of the cabinet.
7. Install bypass handle to the air maintenance device:
a) Bypass handle, part of FPS-00900-Reliable-04, will come pre-assembled.
b) It will need to be connected to the AMD by threading a nipple into both parts.
c) The threads are 1/2” NPTF. Ensure that they are taped sufficiently to seal.
8. Plumb all fittings as specified in product general arrangement drawing (Refer to applicable labels
and General Arrangement drawing for connections.)
a) Qty: 7 - 1/4” PTC OD tube fitting from valve cabinet
b) Qty: 5 – 1/4” PTC OD tube fitting from sieve bed assembly
c) Qty: 1 – 1/4” PTC OD tube fitting from compressor assembly
d) Qty: 2 – 1/4” PTC OD tube fitting from nitrogen tank
e) Qty: 1 – 1/2” PTC OD tube fitting from nitrogen tank
f) Qty: 1 – 1/2” PTC OD tube fitting from air bypass valve
g) Qty: 1 – 1/2” NPT male fitting to AMD (AMD provided by others)
h) Qty: 1 – 1/2” NPT female fitting to air bypass compressor outlet
i) Qty: 1 – 1/4” PTC OD tube fitting from bypass handle assembly to valve cabinet
9. Apply external electrical connections to the unit and bypass handle sensor via quick connector
plugs and wire leads, as shown on the General Arrangement drawing.
a) Connect and wire compressor electrical using supplied quick disconnect.
b) Connect and wire main power using supplied 16’ power cable with flying leads.
c) Connect and wire alarm connection customer contact, alarm process using. supplied 16’ of
wire.
d) Connect and wire magnetic switch to bypass handle assembly using supplied quick
disconnect.
To Next Page
Loading...
Need help?
General
