ST STM32 NUCLEO-F411RE User Manual

Hardware layout and configuration UM1724
18/68 UM1724 Rev 14
6.2.3 Using the ST-LINK/V2-1 to program and debug the STM32 on board
To program the STM32 on the board, plug in the two jumpers on CN2, as shown in red in
Figure 8. Do not use the CN4 connector as this could disturb the communication with the
STM32 microcontroller of the STM32 Nucleo board.
Figure 8. Connecting the STM32 Nucleo board to program the on-board STM32
6.2.4 Using ST-LINK/V2-1 to program and debug an external
STM32 application
It is very easy to use the ST-LINK/V2-1 to program the STM32 on an external application.
Simply remove the two jumpers from CN2 as illustrated in
Figure 9: Using ST-LINK/V2-1 to
program the STM32 on an external application, and connect the application to the CN4
debug connector according to Table 5.
Note: SB12 NRST (target STM32 RESET) must be OFF if CN4 pin 5 is used in the external
application.
MS34378V2
CN2 jumpers ON
CN4 SWD
connector

ST STM32 NUCLEO-F411RE Specifications

General

Microcontroller	STM32F411RET6
Core	ARM Cortex-M4
Operating Voltage	3.3V
Input Voltage	7V to 12V
Operating Frequency	100 MHz
Flash Memory	512 KB
SRAM	128 KB
Digital I/O Pins	50
Analog Input Channels	16
DAC Channels	1
On-board Debugging	ST-LINK/V2-1
Communication Interfaces	I2C, SPI, USART
USB	USB 2.0
Connectors	Arduino Uno
Form Factor	Nucleo

Summary

Quick Start Guide for STM32 Nucleo Boards

Getting Started with the Nucleo Board

Step-by-step guide to configure and launch the demo software on the board.

Hardware Layout and Configuration

Embedded ST-LINK/V2-1

Integrated ST-LINK/V2-1 debugger/programmer, supporting SWD and new features.

Power Supply and Power Selection

Explains powering the board via USB or external sources, including VIN and E5V.

ARDUINO® Connectors

Pin assignments and compatibility for ARDUINO® Uno V3 connectors.

ST Morpho Connector

Pin assignments for the ST morpho connector for board expansion and probing.

Nucleo-64 Boards Information

Board Revision History

Details the evolution and changes across different board revisions.