6
ASSEMBLY AND OPERATION
FUEL AND CHAIN OIL
Mix gasoline (leaded or unleaded, alcohol-free) and quality proven 2-stroke motor oil (FC grade) for air
cooled 2-cycle engines.
Most engine troubles are caused, directly or indirectly, by the fuel used on the machine. Take special care
not to mix a motor oil for 4-cycle engines.
Chain Oil: Use motor oil SAE#10W-30 all year round or SAE#30-#40 in colder temperatures
1. Fill the fuel and chain oil tanks respectively and tighten the caps securely. (F7)
2. Set the switch to the “1” position (F8)
3. While holding the throttle lever together with the throttle interlock, push in the
side throttle lock button and release the throttle lever to hold it at the starting
position. (F9)
1. Chain Oil
2. Fuel
3. Switch
4. Throttle Lock Button
5. Throttle Level
6. Throttle Interlock
7. Choke Knob
4. Pull out the choke knob to the closed position. (F10)
NOTE: When restarting immediately after stopping the engine, leave the choke
knob at the open position.
5. While holding the Chainsaw unit securely on the ground, pull the starter rope
vigorously. (F11)
6. When the engine has ignited rst, push in the choke knob and pull the starter
again to start the engine.
7. Allow the engine to warm up the throttle lever pulled slightly.
NOTE: After Starting the engine, run the chain at medium speed and see if the
chain oil is scattered off as shown. (F12)
STARTING THE ENGINE
To Next Page
Loading...
General