21
Iss 3
Operating your Scooter
Basic Driving
1. Make sure you are properly seated on the scooter and that the Speed
Control knob is turned fully to the left, towards No 1.
Note: Reverse movement of the scooter may not occur when
Speed Control Dial is turned fully anticlockwise and
reversing up a slope.
2. Turn the key switch to the On position.
3. On the tiller, use the throttle lever as described earlier. You will gently
accelerate. Release and you will gently stop. Practice these two basic
functions until you get used to them.
4. Steering the scooter is easy and logical. Be sure to remember to allow
enough clearance when turning corners so that the rear wheels clear any
obstacle.
5. Shortcutting a pavement corner can cause the back wheel to go off the
pavement, causing problems, if the corner is very rough. Avoid this at all
times by steering an exaggerated curve around the obstacle.
6. When steering in a tight spot, such as entering a doorway or when
turning around, stop the scooter and then turn the handlebar to where
you want to go, then apply power gently. This will make the scooter turn
very sharply. It is also recommended that the preset speed is set to a
slower setting to aid control in tight spots.
Exercise caution when reversing
7. Reversing requires attention.
Right hand push or left hand pull operation of the throttle lever will move
the scooter in reverse.
When reversing, always turn the handlebars in the opposite direction to
the way you want to go.
The more you pull the throttle lever, the faster you will go.
Reverse speed is 50% slower than forward speed. If the scooter does
not move in reverse, carefully turn the speed control knob clockwise until
the scooter moves gently backwards.
To Next Page
Loading...
Need help?
General
