38
FR
EN
Problems Probable causes Solutions
Qualication
required
No engine start
The power cable is defective
Check the integration of the
power cable, change the
power cable if needed
After sales
service
The trigger is defective Change the trigger
After sales
service
Power supply is defective Check your electrical network
Self-protection mode of the
machine is activated.
Wait for the product to recover
Abnormal
vibration
Nuts / screws are not well
tight
Screw the nut(s) / screw(s) -
Spool damaged
Check the integrity of the
spool and/or change it if
necessary
After sales
service
Excessive noise
Nuts / screws are not well
tight
Screw the nut(s) / screw(s) -
Poor trimming
quality
There is no more line on the
spool
Change the line
After sales
service
The automatic system of the
spool is defective
Change it by a new one
The engine lacks
of power
The carbon brushes are
about to be consume
Change carbon brushes/
spring/support
After sales
service
The carbon brushes spring
is not enough strong
9. END OF LIFE
Electrical products should not be discarded with household products. Used electrical products
must be collected separately and disposed of at collection points provided for this purpose.
Talk with your local authorities or dealer for advice on recycling.
To Next Page
Loading...
Need help?
General