Stiga A 1500 User Manual

40 EN
4. INSTALLATION
The “Settings" section allows users to:
• Select either “Spot Cut “ or “Scheduled" cutting mode.
• Set-up or change the work programme.
• Set-up or change the cutting height.
• Calibrate the positioning of the robot lawn mower in the charging base.
• Start the hibernation procedure for winter storage.
• Activate and select the rain sensor sensitivity.
• Activate the anti-theft function.
• Activate additional functions.
The "My Garden" section allows users to:
• Record virtual boundaries, transfer routes and areas to be avoided using the app wizard.
• Display the garden map with recorded items and the robot lawn mower's real-time position.
• Set the desired cutting direction.
• Start the robot lawn mower to work in a specic area of the garden.
4.7.6. CONFIGURATION OF THE CHARGING BASE
Before using the robot lawn mower, the charging base must be congured, (see par. 4.7.3).
4.7.7. CALIBRATION OF THE CHARGING BASE
Immediately after completing the charging base set-up, it is mandatory and required by the app to
calibrate the return to base position.
The calibration allows the robot lawn mower to determine the correct alignment to the charging contacts,
using the reading of the radio signal emitted by the antenna located underneath the base of the charging
base.
Procedure:
1. Place the robot lawn mower on the charging base and connect it to the charging contacts.
2. If necessary, lift the robot lawn mower slightly by the rear handle and align it with the charging base to
make sure it is perfectly aligned with it.
3. Check on the robot lawn mower keypad whether the 'ALARM' light icon is switched o, if not, reset the
alarms before proceeding (see section 5.3.7).
4. Close the cover.
5. Start the calibration following the App Calibration Wizard.
6. Wait until a calibration conrmation message appears.
NOTE: If the procedure is not completed within 5 minutes after connecting the robot lawn mower
to the charging contacts, the calibration is cancelled. It is necessary to disconnect the robot from
the charging contacts and repeat the procedure from step 1.
4.7.8. INITIALIZATION OF THE ROBOT LAWN MOWER
The initialization of the robot lawn mower is mandatory and required by the app:
• When starting the product for the rst time.
• When the robot lawn mower is switched on or restarted.
• When the robot lawn mower is moved manually.

Stiga A 1500 Specifications

General

Brand	Stiga
Model	A 1500
Category	Lawn Mower
Language	English