EN - 6
D. Cutting means
designed to cut the vegetation
1. Cutting line head:
2. 3-point blade:
3. Saw blade
E. Cutting means guard:
F. Front hand grip:
G. Rear hand grip: used to handle the
H. Leg guard:
I. Handle bar:
control buttons on the right hand side.
J.
K. Harness:
1. single belt
2. double belt
3.
L. Blade protection
4. ASSEMBLY
IMPORTANT The safety regulations to
follow during machine use are described
in Chapter 2. Strictly comply with these
instructions to avoid serious risks or hazards.
Unpacking and completing the
assembly should be done on a at and stable
surface, with enough space for machine
handling and its packaging, always making
use of suitable equipment. Do not use the
machine until all the instructions in the
“ASSEMBLY” section have been carried out.
4.1 ASSEMBLY COMPONENTS
4.1.1
1.
2.
box, including these instructions.
3.
4.
5.
4.2 HANDLE ASSEMBLY
4.2.1
1.
holes on the drive tube.
2.
3.
4.2.2
1. Fig. 4.A
Fig. 4.B
2. Fig. 4.C
sure that the controls are on the right.
3.
Fig. 4.BFig. 4.A
4. Fig. 4.D
Fig. 4.E
NOTE By loosening the knob (Fig.
4.A), you can turn the handlebar
to reduce its size for storage.
To Next Page
Loading...
Need help?
General
