EN - 15
2.b
–
3.
8.4 SPARK PLUG
8.5 CUTTING MEANS MAINTENANCE
indicated on the Technical Data table
Do not touch the cutting means until
the spark plug cap has been removed and
the cutting means is completely stationary.
Wear protective gloves.
8.5.1
For safety reasons, sharpening
and balancing should be done by a
Specialised Centre with suitable skills
and equipment for the job; without
risking any damage to the blade which
would make it unsafe when used.
3-point blades can be used on both sides.
can be turned and the other side used.
When both sides of the points are
The saw blade is not reversible, thus
it must only be used from one side.
8.5.2 Blade replacement
The blade must never be repaired,
but must be replaced as soon as
signs of breaking are noted or the
sharpening limit is exceeded.
8.5.3 Replacing the cutting line head
8.6 SHARPENING THE LINE
CUTTING KNIFE
•
•
careful to retain the original cutting angle.
•
8.7 TUNING MINIMUM SPEED
If the cutting means moves when the
engine is running idle, contact your dealer
to have the engine adjusted correctly.
8.8 CARBURETTOR
9. STORING THE MACHINE
IMPORTANT The safety regulations to
follow for putting into storage are described
To Next Page
Loading...
Need help?
General
