EN - 5
5.3
Do this when the cutting means is stationary.
• Adjustment (
6. USING THE MACHINE
IMPORTANT For instructions regarding the batteries,
refer to the specic manual.
6.1 PRELIMINARY PROCEDURES
6.1.1
NOTE This machine can be used to mow lawns in vari-
ous ways.
a.
the grass catcher:
1.
-
2. I.
3. I.
b.
discharge on the ground:
1.
(Fig.15.B).
2.
lever (Fig. 15.D).
c.
(Fig. 16.D).
d. -
charge on the ground:
1.
place.
2.
discharge guard (Fig.17.D).
Insert the side discharge chute (Fig.17.E).
the side discharge chute (Fig.17.E).
5.
discharge guard (Fig.17.D).
6. Release the side discharge chute (Fig.17.E).
6.2
Always carry out the safety checks before use.
6.2.1
• -
• -
• .
6.2.2 Machine operating test
Action Result
1.
2. Enable the cutting
3. Release both oper-
ator presence levers
1.
2.
3. The levers should
seconds.
1.
2. Operate the drive lever
3. Disengage the drive
lever.
1.
2.
3.
Test driving
If any of the results fail to match the indications
provided in the tables, do not use the machine! Contact
an Authorised Service Centre to have it checked and
repaired if necessary.
6.3
NOTE Start up the machine on a at surface without ob-
stacles or high grass.
1.
-
2.
3.
to "ON" position.
4.
5.
handle and then the button (Fig.21.B).