EN - 6
6.4 OPERATION
IMPORTANT When working, always keep a safe dis-
tance from the cutting means, given by the length of the
handle.
IMPORTANT To guarantee optimal machine operation, it
is recommended to use two batteries at the same time.
described in (par. 7.2.1).
IMPORTANT If the motor stops because it is overheated
whilst mowing, you must wait approximately 5 minutes be-
fore restarting it.
6.4.1 Grass cutting
1.
2. Adjust the speed and cutting height (par. 5.6) ac-
It is advisable not to
3. -
(Fig.22).
For side discharge:
For mulching or rear grass discharge:
•
single pass (Fig.22).
•
6.4.2
1.
2.
6.5 STOPPING THE MACHINE
1.
2.
After stopping the machine, it will take a few sec-
onds for the cutting means to stop.
IMPORTANT Always stop the machine.
•
• When driving on grass free surfaces.
•
• Before adjusting the cutting height.
•
• -
6.6 AFTER OPERATION
1.
2.
IMPORTANT Remove the safety key whenever the ma-
chine is unused or left unattended.
7. MAINTENANCE
7.1 GENERAL INFORMATION
Before proceeding with any inspections, cleaning or
maintenance/adjustment operations on the machine:
• Stop the machine.
• Make sure that any moving component has stopped.
• Wait until the engine cools down.
• Remove the safety key.
• Read the relevant instructions.
• Use suitable clothing, protective gloves and gog-
gles.
7.2 ROUTINE MAINTENANCE
•
in the "Maintenance Table" (chapter 10).
IMPORTANT Any maintenance and adjustment opera-
tions not described in this manual must be carried out by your
Authorised Service Centre.
7.2.1
1.
2.
3.
charger (Fig.25.C).
4.
plate.
5.
NOTE The battery is equipped with a guard that inhibits
recharging if the environmental temperature is not between
0 and +45 °C.
NOTE The battery can be recharged at any time, even
partially, with no risk of damaging it.
1.
2.
3.
-
trical contact.
4.
To Next Page
Loading...
Need help?
General
