EN - 7
7.3 OCCASIONAL MAINTENANCE
7.3.1 Cutting means
All operations related to the cutting means must be
performed by an Authorised Service Centre.
Make sure damaged, misshapen or worn cutting
means is replaced, together with the securing screws to
preserve balance.
IMPORTANT Always use original cutting means bearing the
code indicated in the 'Technical Data" table.
7.4 CLEANING
7.4.1 Cleaning the machine
•
• -
• Do not use aggressive liquids to clean the chassis.
•
leaves residues or excessive grease.
•
7.4.2
chassis.
For side discharge:
7.4.3 Cleaning the grass catcher (Fig.27.A /B)
7.5 CLEANING THE AIR FILTER
-
1.
2.
(Fig.28.A).
3.
4.
the dust and residues.
5.
8. STORAGE
8.1 STORING THE MACHINE
4. Wait for the engine to cool.
5.
6.
7.
8.
•
•
•
•
8.2 STORING THE BATTERY
NOTE If case of prolonged periods of inactivity, recharge
the battery every two months to prolong its service life
9. HANDLING AND TRANSPORTATION
•
•
•
•
•
or injuries.
•
•
•
•
•
10. MAINTENANCE TABLE
Notes
MACHINE
Before use par. 6.2
General cleaning and inspection-
After each use
-
Before each use
After each use
par. 7.5
To Next Page
Loading...
Need help?
General
