EasyManua.ls Logo

Stiga CR / CS 534 Series - Manutenzione Ordinaria

Stiga CR / CS 534 Series
24 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN - 5
Electric key ignition models


3.2b
Electric push-button ignition models (“III - “IV”)
        -
-

 
         
handle (1).
NOTE Keep pulling the engine / cutting means brake or
the engine will stop.
 -

3.3 Mowing the lawn
         

When the grass catcher is too full, grass collection is no


 
lift the rear discharge guard, grasp the handle and re-

For mulching or rear grass discharge: 
        
than one third of the total grass height per single pass!
-

For side discharge (if applicable):

still to be cut.
For a grass catcher with contents indicator device
(if applicable):      



Lawn care recommendations
       
         






         
“spotted” appearance;
          

 -

 


3.4 When work is finished


Electric key ignition models

Electric push-button ignition models

WAIT UNTIL THE CUTTING MEANS STOPS before pro-

4. ROUTINE MAINTENANCE

IMPORTANT Routine and accurate maintenance is es-
sential in maintaining original machine safety and perfor-
mance levels.
-
-
ble disconnected.
       -

        
-
    

          
-


 -
-
-
-

chute (if installed – see 3.1.d)..
5) Do not drip petrol onto the plastic parts of the engine or



 
  
   
        

        -
       
       -
ing indicated in the engine’s Instruction Manual.
The oil can be discharged at a specialised ser-
        -
         
        -
        
Remember to top-up with oil before using the ma-
chine again.
4.1 Cutting means maintenance





      


        

         

Related product manuals