EN - 18
IMPORTANT In order not to compromise
the eciency of the electromagnetic clutch:
- do not let the clutch come into contact with oil;
- do not spray pressurised water
directly on the clutch unit;
- do not clean the clutch with petrol.
b. Cleaning the exterior
Do not let debris and dried grass
accumulate in the upper part of the
cutting-means assembly in order
to maintain maximum machine
eciency and safety levels.
To clean the upper part of the
•
•
7.6
•
•
•
must be recharged as soon as possible.
IMPORTANT Recharging must be
done using a battery charger at constant
voltage. Other recharging systems can
irreversibly damage the battery.
•
the corresponding connector for the special
(if
IMPORTANT This connector must
only be used for connection to the
maintenance battery-charger indicated
by the Manufacturer. For its use:
follow the instructions given in the
relative instructions manual;
follow the instructions in the battery manual;
7.7 NUTS AND BOLTS
•
8.
8.1
You must go to a specialized
Service Centre or contact your Dealer
if the following are malfunctioning:
- the brake
- the cutting means engage
and disengage functions
- switching the drive to forward
or reverse gears.
8.2
/ CUTTING MEANS
8.2.1 Aligning the cutting-means assembly
8.2.2 Cutting means
All work on the cutting means
(disassembly, sharpening, balancing,
repairing, reassembly and/or replacing)
are demanding jobs that require special
skills as well as special tools. For
safety reasons, these jobs are best
carried out at a Specialised Centre.
Make sure damaged, misshapen
or worn cutting means are replaced
as a whole unit, together with its own
screws in place to preserve balance.
IMPORTANT Cutting means should
be replaced in pairs, especially when
there are marked dierences in wear.
To Next Page
Loading...
Need help?
General
