EN - 6
J 4
4.1.1
1.
2.
box, including these instructions.
3.
4.
5.
4.2 MOUNTING THE FORWARD
CONTROL AND AUGER CABLES
NOTE The cables are already
tted in the dashboard.
4.3 HANDLE ASSEMBLY
lever grips are delivered in a separate
1.
2.
3.
4.3.1 Lever grips assembly
4.4 GEAR LEVER ASSEMBLY
1.
gear lever in the hole of the lever
2.
4.5 DISCHARGE CHUTE ASSEMBLY
1. Put the discharge chute
holes at the base of the chute coincide.
2.
4.5.1 Connecting the discharge
chute guide cable
The purpose of the guide cable is to connect
the discharge chute to the guide handle
guiding the chute in the desired direction.
1.
4.5.2
ST 526 S, ST 625, ST
665, ST 665 T, ST 726 T
the chute to guide it in the desired direction.
1. Insert the end of the guide cable
2. Insert the cotter pin on the pin
3. Insert the
4. Pass the cable on the oil plug fair-lead
4.5.3 Fastening the guiding connectors
the discharge chute in the desired direction.
Fasten the connectors of the dashboard
Pass the cable through the fair-lead
4.6 MOUNTING THE AUGER
thus easier and faster operation.
To Next Page
General
