EN - 12
the tank with a fuel quantity sucient
for nishing the last use (cap. 8).
7.3
Always check the oil level before use.
NOTE The machine is delivered
to the user without engine oil.
7.3.1
•
• Clean around the p
ve it. Clean the rod.
•
•
• 15.K).
•
the
•
procedure, see par. 7.3.2
Do not overll as this could
cause the engine to overheat. If the
oil level exceeds the “H” mark, drain
until the correct level is achieved.
NOTE For the oil type to be used,
see the "Technical data table".
7.3.2 Replacement
The oil may be very hot if removed
just after the engine has been switched
o. Consequently allow the engine to
cool down for a few minutes before
proceeding to drain o the oil.
Replace the engine oil at the intervals
1.
2. Place a collection container
next to the discharge pipe.
3. 15.K).
4. 15.J).
5. Collect the oil in a suitable vessel.
6. .
7.
8.
"Technical data table".
9. Upon each refuelling, start the engine
and let it run for at least 30 seconds.
10.
11. Stop the engine. Wait for 30 seconds and
IMPORTANT Hand the spent
oil over to a disposal facility in
accordance with local provisions.
7.4 CLEANING
Perform the cleaning operations with
the machine switched o. Do not attempt
to remove the snow from the discharge
before having rst performed the following:
• Release the auger control.
• Switch o the engine.
• Remove the ignition key.
•
•
•
•
IMPORTANT Never use pressurised water.
It may damage the electrical components.
7.5 SPARK PLUG
plug, refer to a Dealer or an Authorised
7.6 CARBURETTOR
To Next Page
Loading...
Need help?
General
