67
SWP 355
EN
if they are heated to too high temperatures.
•
the bristles!
• Do not use a hot air blower. If the air is too
Bent bristles can be straightened out again
with heating by means of a warm air fan (e.g.
hairdryer).
• Point the switched-on warm air fan towards the
bent bristles.
»
straighten out again by themselves.
• Do not use a degreasing agent.
• Do not use any aggressive cleaning agents.
• Do not clean the device with a high-pressure
cleaner or under running water. The device
may not be immersed in water or cleaned with
water.
• Protect the bearings against moisture.
•
sweeping roll with compressed air.
» The strong air jet can damage the bristles.
1.
roll and the drives with a wet cloth.
2. Clean all plastic parts with a damp cloth.
CAUTION
Tipping over of the telescopic bracket may
persons.
•
telescopic bracket cannot tip over.
1. Press the lock springs (1) inwards on both
released for removal.
2. Pull the telescopic sliding bracket (2) out of
both handles (3) simultaneously.
• Dispose of the device in an environmentally
friendly manner in accordance with the
applicable regional regulations.
1
2
3
2
3
1
To Next Page
Loading...
Need help?
General
