Rewind
starter
loosen
ing the fastening screws
Rer>laclng
a broken
ataf1er
rope:
Unscrew the 4 screws holding the fan cover and remove
fan cover. On
090 G, however, first remove handle tube
support. Pry off the retainer washer from starter shaft with
a scr
ew
driver thereby holding brake washer
in
place in
orner to avoid that
~
Jumps out thereby loosing the brake
spring.
Now the component
parts
of
the rewind starter can be
removed.
Be careful when removing
the
rope pulley. The hooked in
rewind sprtng must
not
jump
out. Remove
the
remaining
piece
of
the old starter rope, thread in
anew
rope
of
4.5 mm
(Q
.18 In.)
!1l
.and 1000
mm
(39.4 In.) length and secure
In
the
pulley with a single
knot
Thread the other end of
the
rope through
the
rope bushing In the fan cover and secure
it in the starter grip with a double
knot
Don't wind
up
the
rope.
Mount rope pulley onto
the
starter shaft thereby applying
some oil and
take
care
that
the
cast lug
of
the
rope pulley
34
Is
hooked properly Into
the
loop
of
the
rewind spring.
Top
:
Prying
oft
the
ret:alnerwasher
Bot\om: Component parts
To Next Page
Loading...
Need help?
General
