0458-807-8621-A
26
English
23 Troubleshooting Guide
23.1 Blower and Battery
23 Troubleshooting Guide
Always remove the battery before carrying out any inspection, cleaning or maintenance.
Condition LEDs on
Battery
Cause Remedy
Blower does not start
when switched on.
No electrical contact
between blower and
battery.
► Remove the battery, @ 14.2.
► Visually check the electrical contacts in the battery
compartment and on the battery.
► Reinsert the battery, @ 14.1.
1 LED flashes
green.
Battery has low
charge.
► Charge the battery, @ 11.
1 LED glows
red.
Battery too hot / too
cold.
► Allow the battery to warm up or cool down gradually at
ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
4 LEDs flash
red.
Malfunction in
battery.
► Remove the batter and reinsert it, @ 14.
► Switch on the blower, @ 15.1.
► If the LEDs continue to flash, do not attempt to use.
The battery has a malfunction and must be replaced.
3 LEDs glow
red.
Blower too hot. ► Allow the blower to cool down.
3 LEDs flash
red.
Malfunction in
blower.
► Remove the battery and reinsert it, @ 14
► Switch on the blower, @ 15.1.
► If the LEDs still flash, do not attempt to use.
The blower has a malfunction and must be checked by a
servicing dealer.
Blower cuts out
during operation.
1 LED glows
red.
Battery too hot / too
cold.
► Remove the battery, @ 14.2.
► Allow the blower and battery to cool down gradually at
ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
3 LEDs glow
red.
Blower too hot.