Original Instruction ManualPrinted on chlorine-free paper
Printing inks contain vegetable oils, paper can be recycled.
© ANDREAS STIHL AG & Co. KG, 2017
0458-229-8621-A. VA2.G17.
0000007325_005_GB
FC 91
English
1
{
This instruction manual is protected by copyright. All rights reserved, especially the rights to reproduce, translate and process
with electronic systems.
Contents
Allow only persons who fully understand
this manual to operate your edger.
To receive maximum performance and
satisfaction from your STIHL edger, it is
important that you read, understand and
follow the safety precautions and the
operating and maintenance instructions
in chapter "Safety Precautions and
Working Techniques" before using your
edger. For further information you can
go to www.stihlusa.com.
Contact your STIHL dealer or the STIHL
distributor for your area if you do not
understand any of the instructions in this
manual.
WARNING
Because an edger is a high-speed
cutting tool some special safety
precautions must be observed to reduce
the risk of personal injury. Careless or
improper use may cause serious or even
fatal injury.
Make sure your unit is equipped with the
proper deflector and handle for the type
of cutting attachment being used.
Always wear proper eye protection.
Guide to Using this Manual 2
Safety Precautions and Working
Techniques 3
Using the Unit 11
Mounting the Loop Handle 13
Adjusting the Throttle Cable 14
Mounting the Cutting Blade 14
Fuel 15
Fueling 16
Starting / Stopping the Engine 17
Operating Instructions 19
Replacing the Air Filter 19
Engine Management 20
Adjusting the Carburetor 20
Spark Arresting Screen in Muffler 20
Spark Plug 21
Storing the Machine 22
Replacing the Depth Wheel 22
Replacing the Skirt 23
Replacing the Cutting Blade 23
Checking and Replacing the Wear
Guard 24
Maintenance and Care 25
Main Parts 27
Specifications 28
Maintenance and Repairs 29
Disposal 29
Limited Warranty 30
STIHL Incorporated Federal
Emission Control Warranty
Statement 30
STIHL Incorporated California
Exhaust and Evaporative
Emissions Control Warranty
Statement 32
Trademarks 34
To Next Page
Loading...
Need help?
General
