FC 95, FC 110
English
26
For periods of 3 months or longer
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
N Remove, clean and inspect the
cutting blade.
N Store the machine in a dry, high or
locked location, out of the reach of
children and other unauthorized
persons.
Have the worn wheel replaced by a
specialist dealer. STIHL recommends
that maintenance and repair work be
carried out only by authorized STIHL
dealers.
Wheel
N End of screw thread (1) is deformed
so that the wingnut (2) cannot be
lost
The wingnut can only be unscrewed
from the screw with lots of force. If the
parts are joined again after this, the
function of the "filler cap retainer" is no
longer assured. In this case, have the
screw and wingnut replaced with new
ones by a specialist dealer.
Removing the skirt
N Undo and remove the screw (1).
N Remove the washer (2)
N Pull the skirt (3) out of the
segment (6) and out of the gap in
the deflector (5)
Storing the Machine Replacing the Depth Wheel
Replacing the Skirt
To Next Page
Loading...
Need help?
General
