If the lawn edges are planted with trees
or bordered by a fence etc., it is
best to use a nylon line head. It achieves
a "softer" cut with less risk of damaging
tree bark etc. than with the polymer
blades.
However, the polymer bladed STIHL
"Polycut" produces a better cut if there
are no plants along the edge of the
lawn. Sharpening is not necessary
and worn cutting blades are easily
replaced.
:DUQLQJ
To reduce the risk of serious injury,
never use wire or metal-reinforced line
or other material in place of the nylon
cutting lines. Pieces of wire could break
off and be thrown at high speed toward
the operator or bystanders.
67,+/$XWRFXWPRZLQJKHDG
Nylon cutting cord advances auto-
matically when tapped against the
ground.
67,+/3RO\FXWPRZLQJKHDG
Uses either nylon lines or nonrigid
plastic blades
,PSRUWDQW
Three rectangular wear limit marks are
applied to the base (periphery) of the
Polycut 10-3. To reduce the risk of
serious injury from breakage of the head
or blades, the Polycut must not be used
when it has worn as far as one of these
marks. It is important to follow the
maintenance instructions supplied with
the head!
:DUQLQJ
Wear limit marks are integrated in the
base of the Polycut 5-3.
Do not use the Polycut 5-3 if one of the
circular holes starts to become
visible or if the projecting rim has
worn away, since the cutting tool may
otherwise shatter and flying objects
could result in injury to the operator or
bystanders.
1
002BA073 KN
2
002BA074 KN
002BA049 KN
)6
To Next Page
Loading...
Need help?
General
