Stihl FS 460 C-M K User Manual

FS 460 C-M K
English
18
Fitting the full harness is described in
detail in the instruction sheet supplied.
N Put on the full harness (1).
N Adjust the length of the strap so that
the carabiner (2) is about a hand’s
width below your right hip.
N Attach the spring hook to the
machine's perforated strip (3).
Find the right attachment point for the
cutting attachment you are using – see
"Balancing the Brushcutter".
N With the unit suspended from the
harness, see how it is balanced and
change attachment point as
necessary:
Circular Saw Blades
Circular saw blades should "hover"
about 20 cm above the ground.
Throwing off the machine in an
emergency
The machine must be quickly thrown off
in the event of imminent danger.
Practice removing and putting down the
machine as you would in an emergency.
To avoid damage, do not throw the
machine to the ground when practicing.
Controls
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and Stop
positions. Depress the stop switch
(…) to switch off the ignition.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position: Ignition is on in this position –
the engine is ready to start and may be
started. The ignition is switched off when
the stop switch is depressed. It is
automatically switched on again after
the engine comes to a standstill.
Fitting the Full Harness
3
002BA411 KN
1
2
Balancing the
Trimmer/Brushcutter
6BA010 KN
Starting / Stopping the
Engine
1
002BA484 KN
2
3

Stihl FS 460 C-M K Specifications

General

Brand	Stihl
Model	FS 460 C-M K
Category	Power Tool
Language	English