FS 460 C-M K
English
25
Installing the Spark Plug
N Screw the spark plug into the
cylinder.
N Press the spark plug boot firmly
onto the spark plug.
N Fit the cap (1) on the shroud from
the rear and push the lug (2) into the
opening (3) in the shroud at the
same time.
N Swing the cap forwards onto the
shroud, insert and tighten down the
screw (4) firmly.
If engine running behavior is still
unsatisfactory after servicing the air filter
and adjusting the throttle cable, the
cause may be the muffler.
Have the muffler checked by a servicing
dealer for contamination
(carbonization).
STIHL recommends that you have
servicing and repair work carried out
exclusively by an authorized STIHL
servicing dealer.
Removing the Rewind Starter
N Take out the screws (1).
N Lift away the rewind starter.
Replacing the Starter Rope and Rewind
Spring
N If either the starter rope or rewind
spring is broken, continue with
"Removing the Rope Rotor".
N If either the starter rope or rewind
spring are being replaced as a
precautionary measure, continue
with the following chapter.