14
English / USA
FS 75
Check wear limit marks at regular
intervals.
Wear limit marks are incorporated in the
base of the PolyCut.
Stop using your PolyCut 5-3
immediately if one of the round holes
(1; arrow) becomes visible, or if the
upright rim (2; arrow) is worn as shown.
Install a new mowing head.
It is essential to observe the wear
limit marks since there is otherwise
a risk of the cutting tool shattering.
Thrown parts may result in personal
injury.
: Fit the loop handle (1) on the drive
tube, 5,9“ (15 cm) forward of the
control handle (2).
: Fit clamp (3) against drive tube and
slide it into the loop handle.
: Insert the square nut (4) in the loop
handle.
: Fit the clamp screw (5) from the
other side and tighten down firmly.
Adjusting loop handle to most
comfortable position
: Loosen the clamp screw (5).
: Slide the loop handle along the drive
tube as required.
: Retighten the clamp screw.
1
002BA073 KN
2
002BA074 KN
Mounting the Loop Handle
3
355BA030 KN
1
2
A
343BA023 KN
5
4
50 mm
( 2" )
To Next Page
Loading...
Need help?
General
