HS 87 R, HS 87 T
English
27
Definitions
1 Starter Grip
The grip of the pull starter, for
starting the engine.
2 Filter Cover
Covers the air filter.
3 Manual Fuel Pump
Provides additional fuel feed for a
cold start.
4 Spark Plug Boot
Connects the spark plug with the
ignition lead.
5 Carburetor Adjusting Screws
For tuning the carburetor.
6 Control Handle
The support handle for the left hand,
located at or toward the rear of the
hedge trimmer.
7 Throttle Trigger Lockout
Must be depressed before the
throttle trigger can be activated.
8 Slide Control
For starting throttle, run and stop.
Keeps the choke partially open
during starting and switches off the
ignition to stop the engine.
9 Throttle Trigger
Controls the speed of the engine.
10 Fuel Filler Cap
For closing the fuel tank.
11 Fuel Tank
For fuel and oil mixture.
12 Muffler
Reduces engine exhaust noises
and diverts exhaust gases away
from operator.
13 Fan Housing
Polymer housing which encloses
the power unit.
14 Choke Lever
Eases engine starting by enriching
mixture.
15 Front Handle with Hand Guard
Handlebar for the right hand at front
of hedge trimmer.
16 Cutting Blades
Steel blades for cutting hedges and
shrubs.
17 Blade Scabbard
Covers cutting blades when hedge
trimmer is not in use.
EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Engine
STIHL single cylinder two-stroke engine
Specifications
A = 300 hours
B = 125 hours
C= 50hours
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Displacement: 22.7 cc
(1.39 cu.in)
Bore: 34 mm (1.34 in)
Stroke: 25 mm (0.98 in)
Engine power to
ISO 7293:
0.7 kW (0.9 bhp)
at 8,500 rpm
Idle speed: 2,800 rpm
Cut-off speed: 9,300 rpm
To Next Page
Loading...
Need help?
General
