10 Installing Guide Wire
10.1 Installing guide wire
Take into account the position of all guide wires
when installing the perimeter wire.
► Take into account the general guidelines for
installing the guide wire
8.2.
► Insert the beginning of the guide wire (1) into
the middle conduit (2) and feed the wire
through.
Push the guide wire (1) upward inside the
docking station.
37 cm (14.5 in.)
15 cm (6 in.)
27,5 cm (10.75 in.)
a
0000100236_001
► Feed the guide wire (1) through until it pro‐
trudes upward for a = 37 cm (length:
1x iMOW
®
Ruler).
1
3
0000100405_0010000100405_001
► Using the appropriate cable marker (3), mark
the guide wire (1) near the housing.
Marking will facilitate the subsequent connec‐
tion to the correct terminal.
► Install the guide wire (1) in the base plate so
that the guide wire lies flat in the cable duct
and is secured by the hook (4).
► Attach the guide wire (1) directly at the base
plate (5) with a fixing pin (6).
► Route the guide wire (1) for b =2 m in a
straight line and at a right angle (90°) from the
docking station to the mowing area.
► Route the guide wire (1) to the wire loop (7) at
the edge of the mowing area. The distance to
circumferential perimeter wire (8) must be at
least c = 27.5 cm.
► Route the guide wire diagonally on inclines.
The distance to the perimeter wire must be at
least c = 27.5 cm.
English 10 Installing Guide Wire
32 0458-012-0101-A
To Next Page
Loading...
Need help?
General
