Stihl ms 192t User Manual

22
English / USA
MS 192 T
You can run chains of different pitches
on this chainsaw – depending on the
chain sprocket (see “Specifications“):
The chain pitch (1) must match the guide
bar. The drive link gauge (2) must match
the guide bar groove width (3).
The pitch is marked in inches on
the sprocket and guide bar (e.g. 3/8
or .325) and the groove width is
additionally marked on the bar in
millimeters (e.g. 1.6).
Do not run non-matching
components together (different
pitches or drive link gauges) since
they will otherwise be damaged
beyond repair within a very short
period of operation.
: Disengage the chain brake:
Pull the hand guard (4) toward
the handle.
: Unscrew the nut (5) and remove
the cover (6).
: Turn screw (7) counterclockwise
until the tensioner slide (8) butts
against left end of housing slot.
: Fit the guide bar over the stud (9)
and engage the peg of the tensioner
slide in locating hole (10).
Mounting the Bar and Chain
001BA105 KN
1
2
3
a
t = a : 2
4
142BA057 KN
5
6
142BA058 KN
142BA059 KN
7
8
142BA060 KN
10
9

Stihl ms 192t Specifications

General

Brand	Stihl
Model	ms 192t
Category	Saw
Language	English