29MS 192 T
English / USA
Chain brake maintenance
The chain brake is subject to normal
wear. It is necessary to have it serviced
and maintained regularly by trained
personnel, such as your STIHL servicing
dealer, at the following intervals:
0 = Engine off –
ignition is switched off
# = Normal run position –
engine runs or can fire
n=Starting throttle position –
this position is used to start the
engine. The Master Control lever
moves to the normal run position as
soon as the throttle trigger is
squeezed.
To move the Master Control lever from #
to
n, press down the throttle trigger
interlock and squeeze the throttle trigger
at the same time.
Starting the engine
Observe safety precautions – see
chapter on "Safety Precautions".
: Press the fuel pump bulb at least
five times – even if the bulb is
already filled with fuel.
Full-time professional
users: every 3
months
Semi-professional
users (in agriculture
and construction): every 6
months
Hobby and
occasional users: every 12
months
Information
Before You Start
Starting / Stopping
the Engine
To Next Page
Loading...
Need help?
General
