MS 201 C-M
English
36
As soon as the engine runs
N Press down trigger lockout (1) and
the pull the throttle trigger (2) at the
same time – the Master Control
lever (3) moves to the run
position (F) and the engine settles
down to idling speed.
N Pull the hand guard back towards
the front handle.
The chain brake is now disengaged –
your saw is ready for operation.
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the clutch and chain
brake.
At very low outside temperatures
N Change over to winter operation if
necessary – see “Winter Operation”.
Stopping the Engine
N Move the Master Control lever in the
direction of STOP or † – when
released, the Master Control lever
springs back to the normal run
position F.
If engine does not start
N Check that all settings are correct.
N Check that there is fuel in the tank
and refuel if necessary.
N Check that the spark plug boot is
properly connected.
N Repeat the starting procedure.
or:
It is possible that the fuel-air mixture in
the combustion chamber is over-rich
and has flooded the engine.
N Remove the spark plug – see
"Spark Plug".
N Dry the spark plug.
N Hold the saw on the ground.
N Push the Master Control lever as far
as stop in direction of STOP or †
and hold it there.
WARNING
An ignition spark may occur if the Master
Control lever is not held against STOP
or †.
N Operate the rewind starter several
times.
N Release the Master Control lever – it
springs back to the run position F.
N Install the spark plug – see "Spark
Plug".
N Hold and start your saw as
described.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
