34
English / USA
MSE 140 C, MSE 160 C, MSE 180 C, MSE 200 C
MSE 200 C
Model MSE 200 C is equipped with an
electronic overload circuit breaker which
measures motor temperature and
current drawn.
: The LED indicator (1) comes on in
case of overload and the power
supply is interrupted. The indicator
goes off after about 2 seconds and
the saw is ready for operation.
: Run your saw for about 15 seconds
off-load. This helps cool the motor
windings.
Note that the overload indicator glows
only as long as the trigger switch is
activated.
During operation
: Check level in chain oil tank.
: Fill up with fresh chain oil when the
level reaches the "min" mark - see
"Filling Chain Oil Tank".
: Start cutting with the saw chain
running.
: Always cut with a properly
sharpened chain and apply only
moderate feed pressure. The
sound and running behavior of the
saw must remain constant. The
motor speed may only drop a little in
the cut – the chain must not jerk
or stop.
: If motor noise drops suddenly or the
chain stops, reduce feed pressure
immediately to avoid overheating
and possible damage to the saw.
When saw is cold
: See “Checking Chain Tension”.
Chain at operating temperature:
The chain stretches and begins to sag.
The drive links must not come out of the
bar groove – the chain may otherwise
jump off the bar.
: Retension the chain –
see “Tensioning the Saw Chain”.
After finishing work
: Disconnect plug from power supply.
: Always slacken off the chain again
after finishing work.
The chain contracts as it cools
down. If it is not slackened off, it
may damage the drive shaft and
bearings.
100BA030 KN
1
Operating Instructions
To Next Page
Loading...
Need help?
General
