Stihl MSE 180 User Manual

35MSE 140 C, MSE 160 C, MSE 180 C, MSE 200 C
English / USA
: Turn the bar over –
every time you sharpen the chain
and every time you replace the
chain – this helps avoid one-sided
wear, especially at the nose and
underside of the bar.
: Regularly clean
the oil inlet hole (1),
the oilway (2) and
the bar groove (3).
: Measure groove depth –
with scale on filing gauge* – in area
used most for cutting.
* see “Guide to Using this Manual”
If groove depth is less than specified:
: Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
: Use a dry brush or similar tool to
clean the cooling slots at regular
intervals.
Taking Care of Guide Bar
2
001BA119 KN
1
3
3
Chain
type
Pitch Minimum
groove
depth
Picco 3/8“ P 0.20"
(5.0 mm)
Rapid 1/4“ 0.16"
(4.0 mm)
Rapid 3/8“; 0.325“ 0.24"
(6.0 mm)
Rapid 0.404“ 0.28"
(7.0 mm)
Motor Cooling
100BA027 KN

Stihl MSE 180 Specifications

General

Brand	Stihl
Model	MSE 180
Category	Chainsaw
Language	English