► Press the spray lance (1) and spray gun (2)
together and turn counterclockwise to the limit
stop.
► Pull apart the spray lance (1) and spray gun
(2).
6.6 Attaching and removing the
nozzle
6.6.1 Attaching and Removing the Nozzle
Attaching the nozzle:
► Push nozzle (1) onto the spray lance (2).
► Turn the nozzle (1) until it engages.
► If the nozzle (1) cannot be pushed easily into
the spray lance (2): Grease the gasket on the
nozzle (1) with grease for fittings.
Detaching the nozzle:
► Press nozzle (1) and spray lance (2) together
and turn until stop.
► Pull nozzle (1) and spray lance (2) apart.
7 Connecting to a water
source
7.1 Connecting the High-Pressure
Washer to the Mains Water
Supply
The water hose must meet the following require‐
ments:
–
The water hose has a diameter of 1/2".
–
The water hose is between 10 m and 25 m
long.
If the high-pressure washer is operated with
sandy water or water from cisterns, a water filter
must be connected to the high-pressure washer.
The water filter filters sand and dirt out of the
water and thus protects the components of the
high-pressure washer from damage.
Depending on the market, the water filter may be
included with the high-pressure washer.
Connecting the water hose:
► Connect the water hose to a tap.
► Turn on the water tap fully and flush the water
hose with water.
Sand and dirt will be flushed out of the water
hose. The water hose will be vented.
► Turn off tap.
► If a water filter needs to be connected:
► Unscrew the connector (1).
► Screw the water filter (3) onto the water
supply and tighten by hand.
► Screw the connector (1) onto the water fil‐
ter (3) and tighten by hand.
► Push the coupling (2) onto the connector (1).
The coupling (2) engages with an audible
click.
► Turn tap fully on.
► If the spray lance is attached to the spray gun:
Remove the spray lance.
► Squeeze the spray gun trigger until an even
water jet is delivered from the spray gun.
► Release the spray gun trigger.
► Lock the spray gun trigger.
► Attach the spray lance.
► Attach the nozzle.
Detaching the water hose:
► Turn off tap.
► Squeeze the trigger of the spray gun until no
more water comes out of the spray gun.
► To unlock the coupling: Pull or turn and hold
the ring (2).
► Pull the coupling off the connector (1).
7.2 Connecting the high-pressure
washer to another water supply
The high-pressure washer can draw in water
from water butts, storage tanks and flowing or
still rivers and lakes.
English 7 Connecting to a water source
12 0458-016-0101-A
To Next Page
Loading...
Need help?
General
