Stihl RE 462 User Manual

RE 362, RE 362 PLUS, RE 462, RE 462 PLUS
English
48
High-pressure hose and spray gun
Fitting
N Push the high-pressure hose (1)
onto the connector (2)
N Attach union nut (3) and screw it on
and tighten by hand
Removing
N Push the coupling (4) in the
direction of the arrow and hold it
N Loosen the union nut (3) and
unscrew it from the connector in the
direction of the arrow
High-pressure hose extension
As a rule, always use only one high-
pressure hose extension – see "Special
accessories"
N Connecting the water hose
Briefly rinse out the water hose before
connecting it to the machine to prevent
sand and other particles from entering
the machine and to purge the air from
the water hose.
N Mesh the jaws with each other and
turn right as far as possible
N Turn on water supply
To vent the system:
N Actuate the spray gun (without
spray lance mounted) until a
uniform water jet emerges
Connection to the drinking water main
When hooking up to the drinking water
main, a backflow preventer must be
installed between the water tap and the
hose. The design of the backflow
preventer must comply with the
applicable country-specific regulations.
If drinking water has passed through the
backflow preventer, it can no longer be
regarded as drinking water.
Follow the rules laid down by the local
water supply company to prevent water
flowing back from the high-pressure
cleaner into the drinking water main.
1
2
3
647BA022 KN
647BA023 KN
3
4
Connecting the water supply
Diameter of water
hose: 3/4"
Length of water hose: min. 10 m (to
absorb pres
-
sure surges)
max. 25 m
9937BA011 KN
003BA004 KN

Stihl RE 462 Specifications

General

Brand	Stihl
Model	RE 462
Category	Paint Sprayer
Language	English