76 SR 430, SR 450
: Remove the fuel hose (1).
Always install new fuel hoses.
Installing
: Push the new fuel hose (1) onto
the new pump's short
nipple (arrow).
0002RA288 TG
1
0002RA289 TG
1
– Pass the new fuel hose (2)
through the opening.
: Push the pump (1) into the new
fuel return hose (2).
: Push the manual fuel pump (1),
shoulder (3) facing the
recess (arrow), into the opening
until the lugs snap into position.
: Push the fuel hose (1) onto the
nipple (arrow).
– Check operation.
– Fuel must be sucked in when
the manual fuel pump is
operated. Check hose
connections if necessary.
– Install the shroud, b 4.4
0002RA290 TG
2
1
3
0002RA291 TG
1
9.11 Fuel Intake
9.11.1 Pickup Body
Any impurities mixed with the fuel
are retained by the pickup body
(filter). The fine pores of the filter
eventually become clogged with
minute particles of dirt. This restricts
the passage of fuel and results in
fuel starvation.
In the event of problems with the
fuel supply system, always check
the fuel tank and the pickup body
first.
– Troubleshooting, b 3.4
Do not use pliers or other pointed or
sharp-edged tools.
Clean the fuel tank if necessary,
– Open the tank cap and drain the
tank.
– Pour a small amount of clean
gasoline into the tank. Close the
tank and shake the saw
vigorously.
– Open the tank again and drain it.
– Dispose of fuel properly in
accordance with environmental
requirements, b 1.1