3.0 FIRST TIME INSTALLATION
After all connections have been made properly, switch on your TV. The language selection will appear
on screen. Use p qt u to select the OSD Language of your preference. Confirm with ENTER on your
remote control.
Then select the country. Use pqt u to select the Country of your preference. Confirm with ENTER on
your remote control.
The next screen appears with the tuner selection. Choose the one you like to use.
Scan type Select which input source you want to use: DVB-S to receive satellite
broadcasts (and if you are equipped with a satellite dish), DVB-T to receive
terrestrial broadcasts or DVB-C to receive cable broadcasts.
3.1 DVB-S installation
Satellite Setting
Press p q to highlight the satellite your dish is aimed at. The signal quality bar on the bottom of the
screen allows you to fine tune the alignment of your antenna for optimum reception. Adjust your
antenna for maximum possible signal quality. When the signal cannot be improved anymore, fix the dish
on this position and press the BLUE Scan button to continue.
Channel Search
Press p q t u to highlight the options of choice and press ENTER to start the channel search.
Scan Mode Choose between Auto Scan (recommended), Blind Scan and Network
Crypted Select FTA Channels to search Free-To-Air channels only or All Channels to search FTA
and Encrypted channels
Service Type Select DTV to search DTV channels only, RADIO to search radio channels only or All for a
complete search.
It is recommended to use the default settings.
3.2 DVB-T installation
Terrestrial Setting
First select the Tune Type by pressing t u to select DVB-T, ATV or DVB-T+ATV (DVB-T to search digital
broadcasts and ATV to search analogue broadcasts). Press q to continue. Press p q t u to highlight
the country that you want to install, then press ENTER to start searching.
NOTE: If you have an active antenna, turn it on by following the instructions in
paragraph 5.4.5 and then repeat the scan.
3.3 DVB-C installation
Cable Setting
First select the Tune Type by pressing t u to select DVB-C, ATV or DVB-C+ATV (DVB-C to search digital
broadcasts and ATV to search analogue broadcasts). Press q to continue. Press p q t u to highlight
the country that you want to install, then press ENTER to start searching.
9
English
English
To Next Page
Loading...
Need help?
General
