1.4 Accessories
Installation Instructions
1 remote control unit
2x batteries (AAA type)
WARNING: The batteries should not be recharged, disassembled, electrically short-circuited, be mixed
or used with other types of batteries. If rechargeable accumulators instead of batteries are
going to be used (e.g. NiMH), we recommend using types with low self-discharge to ensure
long time operation of your remote control.
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices or higher. If your device is not compatible to USB 2.0
specifications, recording, playback and other multimedia functions of the receiver might not work properly.*
To ensure best performance of your USB storage device please format it via your receiver (through the menu
“Media”) to FAT32 system. Other file systems are not supported by the receiver. However, it is possible to use
already NTFS formatted disks.
STRONG cannot guarantee compatibility with all types of USB storage devices.
If you are going to use external USB HDDs (Hard Disk Drives), please consider that power specifications may
exceed the supported output of your receiver (max. 5 V/800 mA). If so, please connect your USB HDD to an
according external power adapter.
It is advised not to store important information on USB storage devices used with the receiver. Always make
backups of data on your USB storage device before using it with this receiver. STRONG will not take responsibility
for any loss of information or circumstances caused by loss of information.
* This user manual describes the full functionality including the recording function and may not be applicable if the software for recording via
USB has not yet been installed.
2.0 YOUR RECEIVER
2.1 DEFAULT PIN: 1234
2.2 Front Panel
Fig. 1
1. IR sensor Point your remote control towards this sensor.
2. Display Indicates current time in STANDBY mode or current channel number in OPERATING
mode
3. Mode indicator RED indicates that the receiver is in STANDBY mode.
GREEN indicates that the receiver is in OPERATING mode.
4. USB Connector for USB storage devices.
2.3 Rear Panel
Fig. 2
1. CABLE IN Connect your receiver to the wall connector provided by the cable operator
2. CABLE OUT Connect your receiver to another digital receiver or to a TV to keep using its internal
(analogue) tuner (loop through function)
3. S/PDIF COAX. Connect your receiver to a digital home theatre, AV receiver or digital audio
amplifier.
4. HDMI Connect your receiver with your TV set using an HDMI cable.
5. TV SCART Connect your receiver with your TV set using a SCART cable.
4
To Next Page
Loading...
Need help?
General
