Signature Polish is available
from Signature Limited
Laboratory, P.O. Box 13436,
Dayton, Ohio 45413-0436;
877-376-5474.
Interior Cleaning
To clean interior surfaces and
removable parts, wash with a
mild solution of soap and luke-
warm water with a little baking
soda. Do not use vinegar. Rinse
and dry thoroughly. Avoid
getting water on lights, control
display panel and Control Center.
To clean the glasswell of Model
680 or 690, use a mild solution
of soap and water with a little
baking soda. Wipe up spills after
removing the dispenser spill grid.
Exterior Cleaning
To clean the exterior of a classic
or platinum stainless steel
model, use a soft, non-abrasive
stainless steel cleaner like
Signature Polish and apply with
a soft lint-free cloth. Carbon
stainless steel can be cleaned
with mild soap and water.
To bring out the natural luster of
all three finishes, lightly wipe
the surface with a water-
dampened microfiber cloth,
followed with a dry microfiber
cloth. All work should follow
the grain direction of the finish.
Better results are obtained by
keeping the cloth in continuous
contact with the metal.
Condenser Cleaning
Clean the condenser area every
three to six months. In all 600
Series models, the condenser is
located behind the grille. First,
remove the grille.
Use a soft bristle brush and
vacuum to remove dust and lint
from the condenser (radiator).
To remove a standard louvered
grille, first remove the grille
screws. NOTE: Grille screws are
accessed with door(s) open. Tilt
the grille forward at the top and
release the springs from behind
the grille, then lift it off.
To remove the grille for Models
601R, 601RG and 601F (framed
and overlay), remove the two
black screws in the lowest
louver in the grille. Tilt the
bottom of the grille out and
away. It will release from the top
of the grille.
21
Cleaning
aring for your sub-Zero
C
aring for y
our sub-Zero
To Next Page
Loading...
Need help?
General
