2-24
BEFORE DRIVING
78RB1-01E
NOTE:
Depending on vehicle’s specifications,
some items may not be displayed.
How to use the setting mode:
1) When the ignition switch is “ON” and
the vehicle is stationary, push and hold
the indicator selector knob (2) until the
display shows “ ”.
2) Turn and/or push the indicator selector
knob (2) to select a function that you
want to set up according to the chart in
the previous page.
3) Turn and/or push the indicator selector
knob (2) to register settings of the fol-
lowing functions.
68PM00272
NOTE:
• As shown in the above illustration, “ ”
indicates on the display of currently set-
ting item.
• To go back to the higher level display
during operation, turn the indicator
selector knob (2) to display “ ” or
“ ” and then push the indicator
selector knob (2).
Time indication of clock “ ”
• : 12-hour format
• : 24-hour format
NOTE:
Default setting for time indication of clock
varies according to the specification.
Additional flashes of the turn signal
“”
• : Turn signal flashes three
times after the turn signal
lever is returned (default set-
ting)
• : Disable the additional flashes
of turn signal
Lighting time of the “To car” function
“ ” (if equipped)
• : Disable the “To car” function
• : 10 seconds (default setting)
• : 15 seconds
• : 20 seconds
• : 25 seconds
Lighting time of the “To home” function
“ ” (if equipped)
• : Disable the “To home” func-
tion
• : 10 seconds (default setting)
• : 15 seconds
• : 20 seconds
• : 25 seconds
• : 30 seconds
Tyre pressure monitoring system set-
ting (if equipped)
• : Comfort Mode (default set-
ting)
• : Load Mode
Refer to “Tyre pressure monitoring system
(TPMS)” in “OPERATING YOUR VEHI-
CLE” section for details.
Initialization setting “ ”
• : Initialize all settings
How to exit the setting mode:
Switch the display to show “ ” and then
push the indicator selector knob (2).
Turn the indicator selector knob
(2).
Push the indicator selector
knob (2).
To Next Page
Loading...
Need help?
General
