To Next Page

To Previous Page

10. Inspection and maintenance before riding

TIRE INSPECTION

 Tires should be checked and inflated with the engine shut off.

 If a tire’s ground contacting curve is abnormal, check it with an air pressure gauge and inflate it to the

specified pressure.

 Tires pressure must be checked with an air pressure gauge when cold.

PLEASE REFER TO SPECIFICATIONS FOR STANDARD TIRE PRESSURE

 Visual check tires for frontal and lateral side

walls for crack or damage.

 Visual check tires for any nails or small stones

wedged in the tread.

 Check the “tread wear indicator” condition to see

if tread groove depth is insufficient.

 A tire with a wear bar showing is worn out and

should be replaced immediately.

CAUTION:

 Abnormal tire pressure, wear, or crack is the most important cause that results in the loss control of

the steering handle and a punctured tire(s).

STEERING HANDLE FRONT SHOCK ABSORBERS INSPECTION

 Perform this check with engine shut off and ignition switch key

removed.

 Visual check front shock absorbers for damage.

 Operate steering handle up and down, and check front shock

absorbers for noises due to bends.

 Check the bolts and nuts of front shock absorbers with wrenches

for tightness.

 Shake steering handle up & down, left & right, and front & rear to

check if it is loosen, has too much resistance and pulls to one side.

 Check steering handle if it is being pulled too tight by the brake

cables.

 Take your scooter to SYM Authorized Dealer or Franchised Dealer

for a check or adjustment if any abnormal conditions are found.

Tread wear

indicator

Crack and

damage

Foreign

materials (nails

or small stones)

Sym MaxSym 600i ABS User Manual

Other manuals for Sym MaxSym 600i ABS