13
10.INSPECTION AND MAINTENANCE BEFORE RIDING
(Please refer to the components location diagram for the following components.)
§ROUTINE INSPECTION §
Is there enough engine oil?
Is it enough? Is it Octane 90 or above
Braking condition?
(Brake lever free play: 10~20mm)
Braking condition?
(Brake lever free play: 10~20mm)
Is tire pressure normal?
(Standard: 1.75kg/cm
2
)
Is tire pressure normal?
(Standard: 2.0 kg/cm
2
for 1 person, 2. 25 kg/cm
2
for 2 persons)
Does the handle vibrate abnormally or is difficult to turn?
Speedometer, lights, and rearview
mirror
Is it operated properly?
Do lights come on? Can it be seen clearly from behind?
Tightness of Main Components
Do the previous troubles still exist?
CAUTION:
If any problem founded during routine inspection, correct the problem before using the
motorcycle again, have your motorcycle checked and repaired by the “SYM dealer or
authorized service personnel” if necessary.
§ENGINE OIL INSPECTION AND CHANGE §
INSPECTION:
1. Use the main parking stand to support the motorcycle on a
level ground, remove the dipstick after engine stopped for
3~5 minutes. Wipe oil off the dipstick and then insert it into
the guide tube again (Do not rotate it.)
2. Remove the dipstick and check whether oil level is in
between the upper and lower marks.
Add oil to upper limit if oil is under the lower limit. (Check
cylinder, crankcase…etc for leakage.)
To Next Page
Loading...
Need help?
General
