TN-906-AN Page 17 of 20
© Tait Electronics Limited 21 December 2005
6 Testing the Connection
Connecting to the
Base Station via the
APS
Once everything has been configured, dial in to the base station via the APS.
1. Run the Service Kit software and click Connect.
2. Select the APS connection previously set up. The following screen
appears, as for a normal (non-APS) connection.
Once the modems have connected and established their protocol, the
following screen appears. This screen is unique to APS connections.
Shortly afterwards, the correct port is connected, and the base station
responds to its connection protocol. The normal base station logon
screen now appears.
3. Continue with the connection session as normal.
4. When you have completed your session, disconnect in the normal
way.
To Next Page
Loading...
Need help?
General
