Operating in conventional mode 49
Scanning
The scan function is used to monitor a programmed group of
channels, looking for activity. When activity is detected on a
scan group channel, the radio stops on that channel. The
amber LED flashes and, if the channel signalling is valid, the
radio unmutes and you can hear the call. Scanning resumes
when the channel is no longer busy or the signalling is no
longer valid.
One or two priority scan channels may be set. These channels
are scanned more often than other channels and are scanned
periodically when a non-priority channel is busy.
Activating scanning
1 Place the microphone on the microphone clip.
2 Press the function key assigned to scanning or scroll to
the scan group. The amber LED glows to show that the
radio is scanning.
3 Press the scanning function key again to cancel scanning.
The amber LED no longer glows.
Nuisance delete
If a member channel of the scan group is busy for a long time
and you do not wish to hear the conversation, you can use
the function key assigned to nuisance delete to temporarily
delete it from the scan group.
Alternatively, press and hold the function key assigned to
scanning.
When the scan group is next selected, the deleted channel is
again part of the scan group.
Priority channels cannot be removed from the scan group
using the nuisance delete function.
To Next Page
Loading...
Need help?
General
