TM9100 Installation Guide Preparing the Installation 11
© Tait Electronics Limited August 2005
1 Preparing the Installation
This section contains the following information:
■ regulations
■ installation tools
■ checking the equipment for completeness
■ choosing an installation configuration.
1.1 Regulations
MPT 1362 Code of
Practice
TM9100 mobile radios should be installed in accordance with the MPT
1362 Code of Practice.
Vehicle
Manufacturer’s
Installation
Instructions
Follow your vehicle manufacturer’s instructions for installing mobile radios.
For more information, refer to the vehicle manufacturer’s website or contact
the vehicle manufacturer’s dealer.
1.2 Installation Tools
The following tools are required to install of the radio:
■ drill and drill bits
■ Pozidriv screwdriver
■ 5/16 inch (8mm) socket
■ RF connector crimp tool
■ fuse crimp tool
■ in-line RF power meter capable of measuring forward and reflected
power at the operating frequency of the radio.
1.3 Checking the Equipment for Completeness
Unpack the radio and check that you have the following:
1. TMAB34 radio body (40W/50W radio), or
TMAB32 radio body (25W radio)
2. TMAC41 control head (including control-head loom)
3. TMAA02-01 microphone, or TMAA02-08 keypad microphone
(including microphone clip and screws)
4. A TMAA03-17 installation kit (40W/50W radio), or
TMAA03-01 installation kit (25W radio), consisting of the
following items:
■ U-bracket
■ thumbscrews
To Next Page
Loading...
Need help?
General
