10 Safety Warnings TM9100 Installation Guide
© Tait Electronics Limited August 2005
Non-standard Radio Installations
The installation U-bracket described in this guide has been designed so that
there is enough airflow around the radio to provide cooling.
If a non-standard installation method is used, care must be taken that
sufficient heat can be dissipated from the heatsink fins and the ridged bottom
surface of the radio.
For this to be achieved, there must be a gap of more than 3/8 inch (10mm)
between the bottom surface of the radio chassis and the mounting surface.
This is illustrated in the following diagram:
Negative Earth Supply
The radios are designed to operate only in a negative earth system.
3/8 inch (10 mm)
mounting surface
To Next Page
Loading...
Need help?
General
