26 Installing the Radio TM9300/TM9400 Installation Guide
© Tait Limited December 2015
Mounting the
Control Head
The control head and its connection loom are delivered separately from the
radio body. Before installing the radio, the control head should be mounted
on the radio body.
The orientation of the radio body determines which way up the control
head is mounted on the radio body.
Notice It may be necessary to mount the radio upside down to main-
tain a gap of more than 3/8 inch (10 mm) for air circulation between the
underside of the radio body and the mounting surface.
1. Plug the control-head loom onto the control-head connector.
Notice When mounting the control head, make sure you do not pinch
and damage the control head loom.
2. Place one edge of the control head on either the top or bottom pair of
snap features on the front of the radio body, then rotate to snap the
opposite edge into place.
Figure 4.1 Mounting the control head
To Next Page
Loading...
Need help?
General
