39
Information for Scrubber Dryer
preventative maintenance is carried out periodically in order to ensure its safe operation. Operators shall be adequately instructed as to the
correct use of the machine.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard
could render this equipment unsafe and the manufacturer can accept no responsibility or liability in this respect.
The use of other brushes may impair safety.
A full range of brushes and accessories are available for this product.
It is essential that this equipment is correctly assembled and operated in accordance with current safety regulations.
When using the equipment always ensure that all necessary precautions are taken to guarantee the safety of the operator and
Wear non slip footwear when scrubbing. Use a respiratory mask in dusty environments.
When cleaning, servicing or maintaining the machine, replacing parts or converting to another function the battery should be removed.
Machines left unattended shall be secured against unintentional movement.
When detergents or other liquids are used, read the manufacturer’s instructions.
This machine is not suitable for picking-up hazardous dust.
The machine is not to be stored outdoors in wet conditions.
This machine is for indoor use only.
NOTES
• Ensure only competent persons unpack / assemble the machine.
• Keep your machine clean.
• Keep your brushes in good condition.
• Replace any worn or damaged parts immediately.
• Ensure that the work area is clear of obstructions and / or people.
• Ensure that the working area is well illuminated.
• Pre-sweep the area to be cleaned.
• Use steam cleaners or pressure washers to clean the machine or use in the rain.
• Use the machine without the solution tanks properly positioned on the machine, as shown in the instructions.
• Run the machine over power cable during operation.
• Lift or pull the machine by any of the operating triggers, use the main handle.
WARNING
CAUTION
ORIGINAL INSTRUCTIONS
READ MANUAL BEFORE USE
COMPONENT INTERVAL INSPECT FOR
Mains Lead DAILY
Brushes DAILY Bristle damage, wear, drive collar wear
Squeegee Blade BEFORE EACH USE Wear, cracks, splits
Filters BEFORE EACH USE Clogging and debris retention
Tanks AFTER EACH USE Rinse dirty water tank after use
DO
DON’T
To Next Page
Loading...
Need help?
General