33
Battery connection diagram
Charging process
Each battery type and/or battery manufacturer requires differ-
ent charging characteristics.
Charging procedure with external charger
After charging
Prior to commissioning
Parking brake
Activation:
Release:
Emergency stop:
Check parking brake and emergency stop
Attention:
Please pay careful attention to the instruc-
tions of use provided by the manufacturer
of the battery-loading device.
Attention:
Incorrect charging characteristics or the
use of inappropriate chargers results in
early failure or the quick destruction of bat-
teries.
Attention:
Persistent short-term use with subsequent
battery charging may cause long-term
damage to the batteries. Standard value:
At least approx. 20% of the available ca-
pacity should be used up before recharg-
ing the battery.
Attention:
In order to achieve their max. possible ser-
vice life, traction batteries must undergo
the complete charging cycle (12-16 hours)
twice a week.
Attention:
Before decommissioning the machine for
a longer period, the batteries must under-
go a complete charging cycle. After com-
pletion, the charger is disconnected from
the machine and/or mains. Batteries grad-
ually discharge. Depending on the type of
battery, they must be recharged after 3-6
months. Before recommissioning, the bat-
teries should undergo another complete
charging cycle.
6 V
6 V
6 V
6 V
Battery Box
100 A
red
red
black
black
Battery
disconnection
socket
Charger
Relay
Machine Power
External Battery
Charger socket
• Connect the external battery charger with the battery iso-
lating plug of the machine.
Attention:
Make sure that the plug is inserted up to
the stop in order to ensure a good electri-
cal contact.
Notice:
All machine functions are deactivated
during charging.
Attention:
Switch off the charger before disconnect-
ing it from the batteries.
Disconnecting the charger while it is still
switched on may result in an explosion in
the battery compartment.
• The electronic system automatically deactivates the park-
ing brake as soon as the driving switch is operated.
• The parking brake is automatically released by operating
the driving switch.
• If the steering or voltage supply fails, the parking brake can
be released by hand. The emergency release button must
be permanently activated.
Notice:
The emergency release only works with an
inserted battery.
Attention:
The parking brake and emergency stop
are important safety elements. Therefore,
their function must be checked regularly in
short time intervals, before using the ma-
chine.
• Switch on the machine (main switch button).
• Press the driving switch while holding the driving handles.
The machine will start to move straight ahead.
• Now press the emergency stop.
Notice:
The machine must abruptly brake to a
complete stop, and drive straight ahead
without steering correction.
Caution:
If one of these functions is not available,
the machine must be decommissioned un-
til professional repair by an authorized
TASKI service partner.
EN
To Next Page
Loading...
Need help?
General
