38
Removing and cleaning the brush
Cleaning the machine
Storing / parking the machine (not in operation)
Service, maintenance and care
The maintenance of the machine is a prerequisite for impec-
cable operation and a long service life.
Service intervals
TASKI machines are high-quality machines which have been
checked for safety in the factory and by authorized inspectors.
Electrical and mechanical parts are subject to wear and aging
after a longer period of use.
Service center
Please always indicate the type and number of the machine
whenever you contact us for order placing or in case of mal-
functions.
The required data are provided on the nameplate of your ma-
chine. The address of your closest TASKI service partner is
provided on the last page of these instructions of use.
Blade replacement
Notice:
Clean the brush whenever cleaning work
is completed.
Attention:
The front door must be closed so as to pre-
vent splashing water from getting to the
electronics of the brush units.
Attention:
Never clean the machine with a high-pres-
sure cleaner or water jet.
Water ingress in the machine may cause
considerable damage to the mechanical or
electrical parts.
• Wipe the machine with a moist cloth.
Notice:
Store the machine with a lifted squeegee,
lifted brush and open tank lid. Thus, the
tank can dry,
and the generation of mold and unpleas-
ant odors is prevented.
Attention:
Never store the machine with discharged
batteries. Otherwise, the batteries will be
damaged beyond repair.
Attention:
Use original TASKI parts only; otherwise,
any warranty and liability claims will ex-
pire.
Attention:
In order to rule out unintended machine
functions, the following must always be
carried out before starting maintenance
works
- the machine must be switched off,
- the emergency stop confirmed.
Signs and symbols:
◊ = whenever cleaning is completed, ◊◊ = every week,
◊◊◊ = every month, ⊗ = service lamp
Activity
◊
◊◊
◊◊◊
⊗
Page
Loading batteries ● 33
Draining and cleaning the recovery and
fresh water tank
●37
Check the intake and suction filter for
contaminations and clean them
●
Check the suction hose for contamina-
tion and clean it
●
Clean all yellow marked parts ●
Clean the brushes ● 38
Clean the suction nozzle / squeegee,
check the blades for wear and change
them, if necessary
●37
Wipe the machine using a damp cloth ● 38
Clean the gasket of the tank cover,
check them for cracks and replace
them, if necessary
●
Check parking brake and emergency
stop button
●33
Maintenance and service program car-
ried out by Diversey service techni-
cians
●
Carefully wipe the ground sensor un-
derside using a wet cloth (please do not
scrub and do not use chemicals as the
sensor glass may become scratched
which results in problems during detec-
tion)
●
• In order to maintain operational safety and readiness for
use, the machine must be serviced after factory set up, 650
working hours or at least once a year.
Notice:
In case of extraordinary use and/or insuffi-
cient maintenance, shorter intervals are
required.
Notice:
Examine the blades of the suction nozzle /
squeegee after each round of cleaning has
been completed and replace them if re-
quired.
Signs and symbols:
◊ = whenever cleaning is completed, ◊◊ = every week,
◊◊◊ = every month, ⊗ = service lamp
Activity
◊
◊◊
◊◊◊
⊗
Page
To Next Page
Loading...
Need help?
General
