EasyManuals Logo
Home>TC-Helicon>Recording Equipment>GO XLR

TC-Helicon GO XLR User Guide

TC-Helicon GO XLR
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
A/D – D/A conversion 24-bit @ 48 kHz
Effects
Reverb, echo, pitch
shifting, gender (formant
shifting), megaphone,
robot, hardtune, sampler
Frequency response 10 Hz to 20 kHz, +0/-2 dB
Dynamic range > 110 dB
S/N ratio > 101 dB
Power Supply / Voltage
Power input
Standard 12 V DC, center
negative
< 1 A (power supply
included)
Adapter 12 V DC / 1 A
Power consumption 10 W
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
GO XLR
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by Music Tribe can void the user’s authority to
use the equipment.
Hereby, Music Tribe declares that this product is in compliance with Directive 2014/35/EU,Directive 2014/30/EU,
Directive 2011/65/EU and Amendment 2015/863/EU, Directive 2012/19/EU, Regulation 519/2012 REACH SVHC and
Directive 1907/2006/EC.
Full text of EU DoC is available at https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S
Address: Ib Spang Olsens Gade 17, DK – 8200 Aarhus N, Denmark
File Downloads

Other manuals for TC-Helicon GO XLR

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TC-Helicon GO XLR and is the answer not in the manual?

TC-Helicon GO XLR Specifications

General IconGeneral
Frequency range10 - 20000 Hz
Channels quantity- channels
Supported sample rates48 kHz
Digital sound processing24 bit
Line Signal-to-Noise Ratio (SNR)101 dB
Equalizer bands quantity4
Headphone connectivity3.5 mm
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Number of microphone inputs1
DJ mixer-
Product colorBlack
USB connector typeUSB Type-B
Fuse1 A
Phantom power48 V
Power consumption (typical)10 W
Weight and Dimensions IconWeight and Dimensions
Depth174 mm
Width285 mm
Height82 mm
Weight1550 g

Related product manuals