TCL 55C825 User Manual

6
Chapter 2 Getting Started
Switching On
Follow the instructions on this page on how to switch on your TV set
and the remote control before going on to following pages describing
how to use the channel set-up procedure.
1. Insert two AAA batteries in the remote control.
Precautions on using batteries:
- Only use the battery types specied.
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
- Do not expose batteries to excessive heat such as sunshine,
re or the like, throw them in a re, recharge them or try to open
them, as this could cause them to leak or explode.
- Remove the batteries from the remote control if you are not using
it for a long period of time.
- Attention should be drawn to the environmental aspects of battery
disposal.
2. Connect the power cable FIRST to the television, THEN to a mains
socket. (Note: If the power cable is connected to the television,
please only connect the power cable to the mains socket.)
Your TV set should only be connected to an AC supply. It must not
be connected to a DC supply. If the plug is detached from the ca-
ble, do not, under any circumstances, connect it to a mains socket,
as there is a risk of electric shock.
Note: The gures are for representation only, the location of power
socket of the television may differ depending on the model.
3. Connect an outside aerial to the Antenna/Cable input socket at
the back of the TV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for
connecting an external aerial or other equipment tted.
Notes:
- If you want to receive the signal from your cable or cable box,
please connect a coaxial cable to the Antenna/Cable input socket
at the back of the TV set.
- If you want to receive the signal from your satellite receiver, please
connect a coaxial cable to the Satellite input socket at the back of
the TV set.
4. When powered on, the TV will be turned on directly or be in
standby mode.
If the power indicator lights up, the TV set is in standby mode.
Press the
button on the remote control or on the TV set to turn
on the TV.
Switching Off
• To put the TV set into standby mode, press the button on the
remote control. The TV set remains powered up, but with low
energy consumption.
• To switch off the TV set, unplug the mains socket from the mains
outlet.

TCL 55C825 Specifications

General

Screen shape	Flat
Response time	9 ms
Display diagonal	55 \
Rotating display	No
Anti-glare screen	Yes
Display brightness	1000 cd/m²
Display technology	QLED
Native aspect ratio	16:9
Native refresh rate	120 Hz
LED backlighting type	Mini LED
Supported video modes	2160p
Viewable size diagonal	1390 mm
Display diagonal (metric)	139.7 cm
Viewing angle, horizontal	- °
Supported graphics resolutions	3840 x 2160
Motion interpolation technology	PPI (Picture Performance Index) 4100
Dynamic contrast ratio marketing name	Mega Contrast
AC input voltage	220 - 240 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Power consumption (max)	240 W
Power consumption (standby)	0.29 W
Ambient mode	Intelligent Picture
Game features	Auto Low Latency Mode (ALLM), Game Master Pro, Variable Refresh Rate (VRR)
Processor cores	4
Audio formats supported	WMA, MP3
Image formats supported	HEIF, JPG, PNG, BMP
Video formats supported	AVI, WMV, MP4, MPG, TS, MKV, WEBM
Picture processing technology	TCL AiPQ 2.0 Engine
High Dynamic Range (HDR) technology	Dolby Vision IQ, High Dynamic Range 10+ (HDR10 Plus), High Dynamic Range 10 (HDR10), Hybrid Log-Gamma (HLG)
Audio decoders	Dolby Atmos, Dolby Digital, Dolby Digital AC4, Dolby TrueHD
RMS rated power	50 W
Number of speakers	2
Video apps	Amazon Prime Video, Netflix, YouTube
Smart modes	Game, Movie, Sports
Lifestyle apps	Google Apps
Operating system version	11.0
Operating system installed	Android
Wi-Fi standards	802.11g, Wi-Fi 4 (802.11n), Wi-Fi 5 (802.11ac), Wi-Fi 6 (802.11ax)
Bluetooth version	5.2
Bluetooth profiles	A2DP, HID
RF connector type	F, IEC
USB 2.0 ports quantity	1
Consumer Electronics Control (CEC)	T-link
Common interface Plus (CI+) version	1.3
Programming period	8 day(s)
Number of OSD languages	39
Firmware upgradeable via	Network, USB
Cables included	AC
Remote control type	RC802NU1
Tuner type	Analog & digital
Number of tuners	1 tuner(s)
Channels quantity	- channels
Analog signal format system	NTSC, PAL, SECAM
Digital signal format system	DVB-C, DVB-S2, DVB-T2
Color name	Brushed Silver Metal
Product color	Silver
Mercury content	0 mg
Panel mounting interface	400 x 400 mm
Package depth	190 mm
Package width	1400 mm
Package height	875 mm
Package weight	29140 g
Truck type	87 cbm
Pallet width	800 mm
Pallet weight	248120 g
Pallet net height	1860 mm
Quantity per truck	224 pc(s)
Quantity per pallet	8 pc(s)
Quantity per pallet layer	4 pc(s)
Harmonized System (HS) code	85287280
Number of layers per pallet	2 pc(s)
Number of pallets per truck	28 pc(s)
Quantity per master (outer) case	1 pc(s)
Master (outer) case GTIN (EAN/UPC)	5901292515706
Maximum number of stacking cartons	3 pc(s)
Battery type	AAA
Battery weight	15 g
Doesn't contain	Mercury
Country of origin	Poland
Repairability index	6.7
Certification	CE

Weight and Dimensions

Depth (with stand)	255 mm
Width (with stand)	1226.7 mm
Height (with stand)	770.95 mm
Weight (with stand)	22000 g
Depth (without stand)	75.6 mm
Height (without stand)	749.95 mm
Weight (without stand)	20000 g